I got the Yeticam kit and it came with the wide angle freano lens. I went to install it with the ridges pointing out but that one can go on 2 different way. Pattern one way or turn it 180 degrees and has a different pattern Tried asking them but no answer.
Ridges towards the PIR and smoth side faceing out. Did you get the mounting bracket with it?
This one isn't round it's rectangle and has 4 larger dots and 15 smaller ones. 4 larger ones are at one end and the 15 smaller one go accross below the 4. So really it can go on 2 different ways. The hole in the board is off center. And yes I got the mounting board.
Last edited by Bearcamp; 09-28-2010 at 03:23 PM.
heres the directions for it
http://www.yeticam.com/Manuals/Contr...etAssembly.pdf
Thanks alot. I looked all over the place for info just not the right place. Thanks again, Bill
Glad to help out. Good luck on your build
Bookmarks