View Full Version : unsoldering?
03-25-2001, 06:21 PM
Just wondering what was the best way to unsolder the original 24vdc blue relay on the Regent MS20C. I will be replacing it with a Radio shack relay. This is my first project so I was wanting to make sure I get it right. thanks
03-26-2001, 03:01 AM
Buy a desoldering tool, or desoldering wick. Both will do a clean job removing the solder after you heat up.
Don't over heat board, do it in small amounts, and check you have not left pieces on board.
04-13-2001, 12:50 PM
yes, get the solder sucker tool, it is almost impossible to remove the relay without it. I did the first one without it and was lucky I did not tear the board up, the rest I have used the solder sucker, it is a breeze now!
Powered by vBulletin® Version 4.1.7 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.