Boar skull mount

[sdbowyer]

Hey guys. I'm all done boiling and whitening my boar skull. This went well. What's the best way to:

A. Attach the 2 parts of the skull together

B. Attach the skull to the mounting board?

I don't want to break or crack anything and I want the jaws to be securly set together. -Oh and open-mouth or closed-mouth?

[wildlifedesigner]

You can take your bottom jaw and take some 20 minute + epoxy and glue it to the top skull where it hinges, be sure that area is clean of grease or any type of sealer. Then when you look at the back of the skull where the brain was, in that hole you will notice that it is thicker . There you can drill a hole to place a toggle bolt, or a bolt with a washer and attach to the panel.